Trane 4Tee Installation Manual4/15/2021
For maximum efficiency, the horizontal drip tray should be removed.Tray removal requires that the coil be removed by sliding the coil out on the coil channel sup- ports.
![]() Loca- Upflow and Downflow tion of power entry is shown in the outline drawing. Use 2.5 clear stickers provided to Replace Remove seal all unused electrical knockouts. DRAINPAN SHOWN TAB - AS MOUNTED IN PLACE ON COIL CHANNEL SUPPORT Figure 11 TO REMOVE BLOWER ASSEMBLY WHEN COIL IN PLACE, PRESS UP ON COIL USING THUMBS WHILE PULLING BLOWER FORWARD. For maximum efficiency and Customer ease of filter maintenance, it is recommended that a properly sized remote filter and grille be in- stalled for horizontal applications. Airflow should Figure 14 not exceed the face velocity of the filter being If the unit is not suspended it must be supported used. For maximum efficiency and Customer ease of filter maintenance, it is recommended that a properly sized remote filter grille be installed for horizontal applications. Airflow should not ex- ceed the face velocity of the filter being used. The factory installed filter should then be removed from the unit. The primary drain line must be trapped with a pack accompanying this unit. Use Teflon tape on the air handler drain line con- and Comfort Control. The use of color-coded low- nections Do Not Use pipe joint compound or PVC voltage wires is recommended. The FAN-OFF period is set on the ECM Fan Control Refer to blower housing for correct setting. The blower off-delay settings are as follows: Switches 1 - 4 Cooling Airflow Switches 5 - 6. ![]() Power wiring and grounding of equipment must comply with local codes. Low voltage wiring to be No. AWG minimum conductor.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |